Additive Resurs for oil of motorcycles 50ml

Additive Resurs for oil of motorcycles 50ml

An additive for restoring and protecting against wear in modern motorcycle engines with a dry or wet clutch.

Features

• Active component: nano-powder of a copper, tin and silver alloy. It enters the friction zone and forms a coating on the surfaces of the components, levelling micro-defects and improving the work of the cylinder-piston group and crankshaft bearings.
• Under temperature and pressure the particles activate and rebuild the surface, reacting mainly to damaged metal.
• The coating has a porous structure that holds oil in the friction zone, protecting parts from wear during cold starts, engine overheating and sharp acceleration and braking.
• The manufacturer states that it restores the cylinder walls, blocks the escape of gases from the combustion chamber, increases compression and eliminates waste oil.
• The manufacturer states that tests show wear reduced by up to 4 times from the first seconds of engine running.

When to use

• Increased fuel consumption.
• Low or unbalanced compression.
• Increased engine noise and vibration.
• Significant engine oil loss.

Use

1. Ideally, change the oil and oil filter before using the additive.
2. Warm the engine to operating temperature, then switch it off.
3. Shake the bottle for 20-30 seconds before adding.
4. Pour the contents into the oil filler neck.
5. Start the engine and let it idle for 10-15 minutes.

Dosage

For an engine oil volume of 2 to 4 litres:

• Up to 100,000 km mileage: 50ml pack.
• 100,000 to 170,000 km: 100ml pack (pour 50ml first, then add the remaining 50ml after driving 100 km).
• Over 170,000 km: 100ml pack (pour 50ml first, then add the remaining 50ml after driving 100 km).